Tecton 12 Ski Bindings

The technology mix of the Tecton with pin unit in front, heel jaws and absolute power transmission for a perfect ride. The low weight, the easy step-in, the same level of safety as alpine bindings, as well as the practical handling make every tour a memorable experience.

• Hold-Down System with Alpine Heel: The heel jaw is pressing the sole of the boot firmly against the heel plate, which is directly connected with the ski, and provides consistent direct traction.
• Alpine Heel with Power Rail: As an absolute novelty, the power rail engages in the back of the boot, secures it in the center and prevents a loss of power.
• Solid, Non-Turning Heel: Unlike other pin bindings, the power flow is not interrupted by a rotating movement when the skis turn.
• Release & Elasticity: The highest elasticity of 13 mm prevents an unwanted release and cushions any lateral impact so that the ski always maintains a firm grip. The pin binding with lateral release and DIN setting at the toe, where the lateral forces are acting in the event of a fall.
• Front Release at the Heel with 9 mm Elasticity: As in alpine bindings, when the DIN value is set, the front release occurs via a heel jaw with a dynamic way of 9 mm. The reset force of the spring prevents a pre-release and compensates the high tensile forces on the leg in a forward fall.
• Release Lever: After the release of the heel, the boot tips forward. Due to the pressure of the front of the boot on the Release Lever, the boot is also immediately released by the toe unit.
• Emergency Release When Climbing: The boot is fixed and held in the middle, but the binding will release in response to high active forces. Clamping systems must be blocked while climbing to ensure stability.
• Solid Stop in Front to Step In: The tip of the boot is optimally positioned by means of a solid stop in front and a positioning guide. Responding to slight pressure, the system closes with the pin levers engaging precisely in the inserts. The sequence of movements is comparable with that of an alpine binding.
• Easy Operation Means More Than Comfort: Switching from downhill to uphill mode and vice versa is very simple without having to step out of the binding. The three ergonomically walk mode levels can also be changed in no time with a pole.
• Swiss Made: All parts are manufactured in Switzerland and assembled into high-quality products in Reichenbach. After the assembly, every binding undergoes a meticulous quality control process, including a functional test.
• Alpine heel with Power Rail
• New Easy Step-In
• Complete easy handling package